The PIC18F47J53 FS USB PIM Demo Board is a full-speed USB demonstration and development board featuring the PIC18F47J53 with XLP low power. The board can be operated either standalone or as a Plug-In Module (PIM) plugged into the PIC18 Explorer Board.
Two miniature SMT red LEDs
12MHz SMT crystal which can be used with internal PLL to run the microcontroller and USB module
MCP9701A Analogue output temperature sensor
General purpose push button S2 connected through with a pull-up resistor
Six-pin, right-angle in-circuit serial programming (ICSP ) programmer/debug header
Jumpers for current measurement (JP3) and configuration (JP2)
A mini-B USB connector for power and communication
Full-speed (12 Mbps) and low-speed (1.5 Mbps) operation
Support of control, interrupt, bulk and isochronous transfers
Support of up to 32 endpoints, 3.8Kbytes of dual access RAM for USB or general purpose use