The device is an integrated H-Bridge for resistive and inductive loads for automotive applications, such as throttle control actuators or exhaust gas recirculation control valves.
The driving strategy is enhanced by configurable PWM / DIR pins and IN1/IN2.
The H-Bridge contains integrated free-wheel diodes. In case of freewheeling condition, the low-side only is switched on in parallel of its diode to reduce power dissipation.
The integrated Serial Peripheral Interface (SPI) makes it possible to adjust device parameters, to control all operating modes and read out diagnostic information.
**Key Features**
AEC-Q100 qualified
Flexible driving strategy via configurable pins PWM/DIR (IN1/IN2)
RDSon < 400 mΩ (full path at Tj =150° C)
Operating battery supply voltage from 4.5 V up to 28 V
Operating VDD5 supply voltage from 4.5 V to 5.5 V
Input switching frequency up to 20 kHz
Built in charge pump supporting 100% duty cycle
Logic levels compatible to 3.3 V and 5 V
Monitoring of VDD5 supply voltage with bidirectional switch-off pin
Current limitation SPI-adjustable in four steps.
Output stage current limitation with dependence on temperature
2 Programmable voltage and current slew rate control
Short circuit and programmable thermal warning and shutdown thresholds
Open Load diagnosis in ON condition
All I/O pins can withstand up to 19 V
SPI interface for configuration and diagnosis
Two independent enable/disable pins NDIS and DIS and SOPC (Switch-off Path Check) available
Spread Spectrum function for EMI reduction
Available in single (L9960) and Twin (L9960T) option, both in PSSO36 package