APS00BHoneywellHoneywell Magnets: MG Series, cast Alnico V cylinderical magnet for actuating Hall-effect sensors, North Pole end is indicated with red, 31,75mm W x 6,35mm Dia [1.25in W x 0.25in Dia]
￥
7.94
显示的图像仅供参考，应从产品数据表中获得准确的规格。
APS00BHoneywell
制造商:
Honeywell
制造商型号#:
APS00B
百芯编号#:
CM4228075
价格(CNY):
￥
7.94
百芯库存:
240
个
库存地点:
可供应量:
140
个在库
此为供应商库存，需要与销售确认
产品类别:
霍尔,传感器
产品描述:
Honeywell Magnets: MG Series, cast Alnico V cylinderical magnet for actuating Hall-effect sensors, North Pole end is indicated with red, 31,75mm W x 6,35mm Dia [1.25in W x 0.25in Dia]
The APS00B is a high resolution angular position Sensor IC, it is a miniature surface mount device for angular or rotary displacement designed for magnetic saturating field sensing. The IC creates an analogue output voltage that varies with the direction of the magnetic flux passing over the sensor IC surface. It contains dual, saturated-mode Wheatstone bridges that generate quadrature (sine and cosine) signals to provide an extended range of angular measurements up to 180°. This product is a cost-effective and space-efficient solution for high-volume OEM designs. Potential applications include position sensing, rotary speed and angle detection and non-contact precision location measurement systems. This sensor IC uses Honeywell"s Anisotropic Magnetoresistive (AMR) technology that provides advantages over Hall-effect-based magnetic sensors.
Wide, angular range allows measurements ±90° and ±180°
Resolution capability of less than 0.05° helps improve overall system accuracy
Absolute sensing, no indexing is required, exact target position is known, simplifying system design
Dual 4-element Wheatstone bridges provide a passive element
Low-noise design
Helps to improve system performance
Typical 0 to 5MHz frequency response with 190G minimum magnetic field applied
Saturated mode
Typically requires only 5V at 4mA to operate (20mW), promoting energy efficiency
Measure only field direction, virtually unaffected by shock, vibration/magnetic-source gap variation
Provides stable and reliable output
Dual bridges with outputs 45° out of phase make it possible to use outputs as speed/direction signal
ESD sensitive device, take proper precaution while handling the device.
APS00A instrumentation amplifier is available separately for additional signal processing.
