下载
EVAL-ADG5249FEBZ User Guide
UG-878
One Technology Way • P. O. Box 9106 • Norwood, MA 02062-9106, U.S.A. • Tel: 781.329.4700 • Fax: 781.461.3113 • www.analog.com
Evaluation Board for the ADG5249F, Overvoltage Protected Dual 4:1 Multiplexer
PLEASE SEE THE LAST PAGE FOR AN IMPORTANT
WARNING AND LEGAL TERMS AND CONDITIONS.
Rev. 0 | Page 1 of 15
FEATURES
Supply voltages
Dual supply: ±5 V to ±22 V
Single supply: 8 V to 44 V
Protected against overvoltage on source pins
Signal voltages up to −55 V and +55 V
LEDs for visual overvoltage indication
Parallel interface compatible with 3 V logic
On-board LDO regulator for digital supply and control,
if required
EVALUATION KIT CONTENTS
EVAL-ADG5249FEBZ evaluation board
DOCUMENTS NEEDED
ADG5249F data sheet
EVAL-ADG5249FEBZ user guide
EQUIPMENT NEEDED
DC voltage source
±22 V for dual supply
44 V for single supply
Optional digital logic supply: 3 V to 5 V
Analog signal source
Method to measure voltage, such as a digital multimeter (DMM)
GENERAL DESCRIPTION
The EVAL-ADG5249FEBZ is the evaluation board for the
ADG5249F, which features an overvoltage protected dual 4:1
multiplexer. The ADG5249F has overvoltage detection and
protection circuitry on the source pins and is protected against
signals up to −55 V and +55 V in both the powered and
unpowered states.
Figure 1 shows the EVAL-ADG5249FEBZ in a typical evaluation
setup. The ADG5249F is soldered to the center of the evaluation
board and wire screw terminals are provided to connect to each
of the source and drain pins. Three screw terminals power the
device, with a fourth terminal used to provide a user defined digital
logic supply voltage, if required. Alternatively, a low dropout (LDO)
regulator is provided for 5 V digital logic supply and to supply
the LEDs, which are mounted to provide visual indication of the
fault status of the switch.
Full specifications on the ADG5249F are available in the product
data sheet, which should be consulted in conjunction with this
user guide when using the evaluation board.
