下载
Cyclone V GX, GT, and E Device Errata
2015.09.18
ES-1035
Subscribe
Send Feedback
This document lists the errata for the Cyclone
®
V GX, GT, and E devices.
JTAG Programming of 28-nm Devices
JTAG configuration of 28-nm devices does not operate correctly when you initiate a PAUSE_DR instruction
during configuration. In this scenario, JTAG configuration fails when pausing configuration in the middle
of the bit stream by entering into the PAUSE-DR state and continuing to clock the TCK input. The failure
is indicated by CONF_DONE staying low after all of the data has been clocked into the FPGA while nSTATUS
remains high.
The PAUSE-DR feature works correctly with normal IEEE 1149.1 JTAG test operations.
Workaround
If you require pausing in the middle of the bit stream during JTAG configuration, halt the TCK and do
not enter the PAUSE-DR state. Restart the TCK when you resume the configuration.
Status
Affects: Cyclone V GX, GT, and E devices
There is no planned fix for this issue.
External Memory Interface (EMIF) Maximum Frequency Specification
Update
Description
To achieve timing closure, the EMIF maximum frequency specification has been updated in the table
below.
©
2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words and logos are
trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as
trademarks or service marks are the property of their respective holders as described at www.altera.com/common/legal.html. Altera warrants performance
of its semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any
products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information,
product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device
specifications before relying on any published information and before placing orders for products or services.
ISO
9001:2008
Registered
www.altera.com
101 Innovation Drive, San Jose, CA 95134
