下载
WILC1000-MR110PA DATASHEET
IEEE 802.11 b/g/n Link Controller SoC
Datasheet
Description
The ATWILC1000-MR110P is a low-power consumption 802.11 b/g/n IoT (Internet
of Things) module which is specifically optimized for low power IoT applications.
The highly integrated module features small form factor
(21.5mm x 14.5mm x 3.4mm) while fully integrating Power Amplifier, LNA, Switch,
Power Management, and PCB antenna. With seamless roaming capabilities and
advanced security, it could be interoperable with various vendors’ 802.11b/g/n
Access Points in wireless LAN. The module provides SPI and SDIO to interface to
host controller.
Features
• IEEE 802.11 b/g/n 20MHz (1x1) solution
• Single spatial stream in 2.4GHz ISM band
• Integrated PA and T/R Switch
• Superior Sensitivity and Range via advanced PHY signal processing
• Advanced Equalization and Channel Estimation
• Advanced Carrier and Timing Synchronization
• Wi-Fi Direct and Soft-AP support
• Supports IEEE 802.11 WEP, WPA, WPA2 Security
• Supports China WAPI security
• Superior MAC throughput via hardware accelerated two-level
A-MSDU/A-MPDU frame aggregation and block acknowledgement
• On-chip memory management engine to reduce host load
• SPI, SDIO, UART, and I
2
C host interfaces
• 2/3 wire Bluetooth coexistence interface
• Operating temperature range of -40°C to +85°C
• Power save modes:
– <1µA Deep Power Down mode typical @3.3V I/O
– 280µA Doze mode with chip settings preserved (used for beacon monitoring)
– On-chip low power sleep oscillator
– Fast host wake-up from Doze mode by a pin or host I/O transaction
Atmel-42380D-WILC1000-MR110PA-SmartConnect-Datasheet_032015
页面指南
