下载
ATWINC1500-MR210PB DATASHEET
IEEE 802.11 b/g/n IoT Module
DATASHEET
Description
The ATWINC1500-MR210PB is a low-power consumption 802.11 b/g/n IoT (Internet
of Things) module, which is specifically optimized for low power IoT applications. The
highly integrated module features small form factor (21.5mm x 14.5mm x 2.1mm)
while fully integrating Power Amplifier, LNA, Switch, Power Management, and PCB
antenna. With seamless roaming capabilities and advanced security, it could be
interoperable with various vendors’ 802.11b/g/n Access Points in wireless LAN. The
module provides SPI and UART to interface to host controller.
Features
IEEE
®
802.11 b/g/n 20MHz (1x1) solution
Single spatial stream in 2.4GHz ISM band
Integrated PA and T/R Switch
Integrated PCB antenna
Superior Sensitivity and Range via advanced PHY signal processing
Advanced Equalization and Channel Estimation
Advanced Carrier and Timing Synchronization
Wi-Fi Direct and Soft-AP support
Supports IEEE 802.11 WEP, WPA, WPA2 Security
Supports China WAPI security
Superior MAC throughput via hardware accelerated two-level A-MSDU/A-MPDU
frame aggregation and block acknowledgement
On-chip memory management engine to reduce host load
SPI, UART, and I
2
C host interfaces
2- or 3-wire Bluetooth
®
coexistence interface
Operating temperature range of -40°C to +85°C
I/O operating voltage of 2.7V to 3.6V
Integrated Flash memory for system software
Power Save Modes
– <4µA Power Down mode typical @3.3V I/O
– 380µA Doze mode with chip settings preserved (used for beacon monitoring)
1
1
See Power Consumption for module power modes.
Atmel-42502B-ATWINC1500-MR210PB-SmartConnect-Datasheet_02/2016
页面指南
